Drive Train |
Engines - Choice of:
20 and 25 hp, aircooled gasoline engines - Kohler
23.5 hp water-cooled
gasoline engine - Briggs & Stratton
26.5 hp water cooled diesel - Briggs & Stratton
255 hp water-cooled diesel - John Deere
Hydrostatic Transaxle
Combination of proven hydrostatic pump
and
high/low range axle
Final Drive
Two-for-one gear-reduction drop axle, providing
increased torque as well as greater ground
clearance
|
Tires |
Rear, 42" O.D., 8.3 X 24 with 45-degree lug
Front, 5.00 X 12
Also available: Rear 9.5 X 24
|
Steering |
Full-time power steering assist |
Lifts |
Front (mid) mount, category 1, three-point hitch. Rear hitch, modified top link on three-point version
(rear engine mount) standard hydraulic quick couple for implement mounted cylinder on water-cooled engine models--plus drawbar with pull point in front of rear wheels. Hydraulic lifts front and back. |
Electrical |
Electric start, 12-volt system
25-amp alternator on air-cooled engines
40 amp alternator on water-cooled systems |
Lighting |
Halogen beams front and back (includes crop row beam) amber flashers, red stop light. |
Frame and Structure |
Main frame component of 2-1/2 inch solid steel bars (not tubes) for strength and weight complement all
heavy-duty components. All models equiped with roll bars and seat belts. |
Ground Clearance |
18
to 21 inches of ground clearance (depending
on implement configuration and tire
selection). Saukville Tractor's new "HB" models
have over 27 inches of ground clearance.
Contact us by phone, fax or email for
more information and pricing.
|
Wheel Width Adjustment |
Rear
and front wheel adjustable from 40 inches to 60 inches in
width. (Can be special ordered to increase to 84 inches in
width.)
|
Fuel Capacity |
More than 10-gallon capacity provides more than normal operating duration -- located in tanks built
into each fender (approximately 5 gallons each). |
Hydraulic Reservoir |
Hydraulic reservoir, over 15 gallons, coupled
with high-quality heat exchanger and powerful
puller fan
virtually
eliminates hydrofluid heat build up outside
of normally accepted operating levels.
Separate hydro pump (optional) acts as PTO
for hydraulically powered implements such
as, but not limited to:
fine-cut
belly mower, front-end loader, power tiller,
etc. See your dealer/distributor for full
specifications when ordering hydraulically
powered implements. (Hoses, fittings, control
valves, pressure
relief
and flow valves, mounting hardware, etc.)
|
Measurements |
Overall length: 144.3 inches
Wheelbase: 84 inches
Weight: 2500 lbs. |
